メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

英語
イタリア語

手順 2を翻訳中

手順2
Use the flat end of a spudger to gently pry the Lightning connector and speaker enclosure assembly cables up from the rear case. Make sure you get the spudger under the large ribbon cable connected to the assembly. Prying the rest of the assembly away from the cable may result in a tear. Make sure you get the spudger under the large ribbon cable connected to the assembly. Prying the rest of the assembly away from the cable may result in a tear.
  • Use the flat end of a spudger to gently pry the Lightning connector and speaker enclosure assembly cables up from the rear case.

  • Make sure you get the spudger under the large ribbon cable connected to the assembly. Prying the rest of the assembly away from the cable may result in a tear.

Usa l'estremità piatta di uno spudger per staccare dal case posteriore i cavi del connettore Lightning e dell'involucro del gruppo altoparlante.

Accertati che lo spudger sia sotto al grande cavo a nastro collegato al gruppo. Far leva sul resto del complesso potrebbe causare uno strappo.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります