メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての5個のガイドに反映されます。

英語
イタリア語

手順 5を翻訳中

手順5
In the following steps, you will be placing the remaining pieces of adhesive on the front panel. Do not peel the brown backing off the strips just yet.
  • In the following steps, you will be placing the remaining pieces of adhesive on the front panel.

  • Do not peel the brown backing off the strips just yet.

  • Place the largest L-shaped adhesive strip on the top left corner of the front panel.

  • Smooth the strip down from the center out, taking care to not trap any air bubbles between the strip and the front panel.

Nei prossimi passaggi, applicherai i pezzi rimanenti dell'adesivo sul pannello anteriore.

Non rimuovere ancora la protezione marrone dalle strisce.

Appoggia la striscia a L più lunga sull'angolo in alto a sinistra del pannello anteriore.

Appiattisci la striscia dal centro verso l'esterno, stando attento a non far formare delle bolle tra la striscia stessa e il pannello.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります