注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。
手順 2を翻訳中
手順2

-
In the following steps you will be cutting through the adhesive on the rear glass panel.
-
Take note of the following areas:
-
In addition to cutting around the edge, there is extra adhesive here that should be cut.
-
Avoid sticking the spudger blade in too far here, to avoid damaging the rear button ribbon cable and chip.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。