注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。
手順 1を翻訳中
手順1

-
Remove four Phillips screws securing the lower display cable bracket to the logic board, of the following lengths:
-
Two 1.3 mm screws
-
Two 2.8 mm screws
-
Remove the bracket.
[* black] Remove |
[* black] Remove |
[* red] Two 1.3 mm screws |
[* orange] Two 2.8 mm screws |
[* icon_reminder] Throughout this guide, [product|IF145-167-4|keep careful track of your screws] so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage. |
[* black] Remove the bracket. |
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。