はじめに

This guide explains how to remove the brushes from your iRobot Roomba 551, either for replacement or cleaning.

Place your Roomba upside-down on a hard surface.
  • Place your Roomba upside-down on a hard surface.

If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

David Forrest - 返信

While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
  • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

コメントを追加する

Gently pull upwards on the brush to remove it.
  • Gently pull upwards on the brush to remove it.

コメントを追加する

Rotate the Roomba upside-down so the bottom is facing towards you.
  • Rotate the Roomba upside-down so the bottom is facing towards you.

コメントを追加する

Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place. Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.
  • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

コメントを追加する

Carefully lift the bottom plate.
  • Carefully lift the bottom plate.

  • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

コメントを追加する

Pinch the yellow tabs on the sides of the brush cage and lift up to open. Pinch the yellow tabs on the sides of the brush cage and lift up to open.
  • Pinch the yellow tabs on the sides of the brush cage and lift up to open.

コメントを追加する

Grab each brush and lift upwards to remove. Grab each brush and lift upwards to remove. Grab each brush and lift upwards to remove.
  • Grab each brush and lift upwards to remove.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

John McTigue

メンバー登録日: 2014年01月31日

331 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 13-14, Regan Winter 2014 Cal Poly, Team 13-14, Regan Winter 2014人のメンバー

CPSU-REGAN-W14S13G14

4 メンバー

13のガイドは作成済み

コメント1件

Should be no need to remove the back plate. Just open the brush cage and lift out the brushes

Gunnar Nybraten - 返信

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 6

今までの合計 811