はじめに

Replace the damaged headphone jack to hear those sweet tunes again.

Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.
  • Widen the small gap between the front and rear case by inserting a metal spudger into the gap near the top of the iPod.

  • Be careful when using a metal spudger, as you may scratch the outer case.

コメントを追加する

Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.
  • Insert an iPod opening tool into the newly widened gap, and pry the rear case up and away from the front case.

コメントを追加する

  • Insert the iPod Shuffle opening tool into the gap between the front and rear case on the same side, at the bottom corner of the iPod.

  • Pry the rear case away from the front case.

コメントを追加する

  • Lift the bottom of the rear case and remove it from the rest of the iPod.

コメントを追加する

  • Disconnect the headphone jack and shuffle switch connector by prying it off the logic board with a spudger.

コメントを追加する

  • Remove the single Phillips screw securing the logic board to the front case.

コメントを追加する

  • Peel the battery up from the front case with an iPod opening tool.

  • Remove the logic board and battery from the iPod.

コメントを追加する

  • Pry the headphone jack from the front case with an iPod opening tool.

  • Don't attempt to remove the headphone jack yet, it is connected to the shuffle switch.

コメントを追加する

  • Using the pointed tip of a spudger, push the shuffle switch in to separate it from the front case.

コメントを追加する

  • Remove the headphone jack and shuffle switch from the front case.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Matthew Newsom

メンバー登録日: 2010年01月05日

31,638 ポイント

93のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 4

過去 30 日: 27

今までの合計 10,761