はじめに

Use this guide to remove your Shuffle's logic board assembly. The logic board assembly includes the logic board, headphone jack, and battery.

Before beginning, be sure your Shuffle is turned off as shown.
  • Before beginning, be sure your Shuffle is turned off as shown.

コメントを追加する

Use the edge of an iPod opening tool to pry the plastic cover off the headphone jack side of the Shuffle. Remove the plastic cover and set it aside.
  • Use the edge of an iPod opening tool to pry the plastic cover off the headphone jack side of the Shuffle.

  • Remove the plastic cover and set it aside.

コメントを追加する

Remove the two Phillips screws from the headphone jack side of the Shuffle.
  • Remove the two Phillips screws from the headphone jack side of the Shuffle.

コメントを追加する

Use the edge of an iPod opening tool to remove the steel cover from the headphone jack side of the Shuffle. Use the edge of an iPod opening tool to remove the steel cover from the headphone jack side of the Shuffle.
  • Use the edge of an iPod opening tool to remove the steel cover from the headphone jack side of the Shuffle.

コメントを追加する

Use the edge of an iPod opening tool to pry the plastic cover off the controls side of the Shuffle. Remove the plastic cover and set it aside.
  • Use the edge of an iPod opening tool to pry the plastic cover off the controls side of the Shuffle.

  • Remove the plastic cover and set it aside.

The On-Off switch here is turn around. Usually it is green when the iPod is turned on.

Nils Kober - 返信

Use a pair of tweezers to remove the hold and shuffle sliders from the Shuffle. Use a pair of tweezers to remove the hold and shuffle sliders from the Shuffle.
  • Use a pair of tweezers to remove the hold and shuffle sliders from the Shuffle.

Thanks for this great instruction. Little note: Not important for the function, but contrary to the images the green side of the on/off-slider originally must point in the opposite (inner) direction.

Martin - 返信

Remove the two Phillips screws on the controls side of the Shuffle.
  • Remove the two Phillips screws on the controls side of the Shuffle.

コメントを追加する

Use the edge of an iPod opening tool to remove the steel plate from the controls side of the Shuffle. Use the edge of an iPod opening tool to remove the steel plate from the controls side of the Shuffle.
  • Use the edge of an iPod opening tool to remove the steel plate from the controls side of the Shuffle.

コメントを追加する

Use the edge of an iPod opening tool to slightly pry the steel plate on the headphone jack side of the Shuffle away from the lip cut into the outer case.
  • Use the edge of an iPod opening tool to slightly pry the steel plate on the headphone jack side of the Shuffle away from the lip cut into the outer case.

コメントを追加する

Use your iPod opening tool to push the logic board assembly out of the outer case enough to grab the logic board by its edges. Pull the logic board assembly out of the outer case.
  • Use your iPod opening tool to push the logic board assembly out of the outer case enough to grab the logic board by its edges.

  • Pull the logic board assembly out of the outer case.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

19 の人々がこのガイドを完成させました。

Andrew Bookholt

491,435 ポイント

1,160のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 9

過去 30 日: 45

今までの合計 16,120