修理を始めるには コミュニティ ストア

iPod Nano 5th Generation Click Wheel Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

はじめに

A prerequisite for removing the logic board assembly.

必要な工具と部品

  1. iPod Nano 5th Generation Click Wheel Replacement, Click Wheel: 手順 1、 2の画像 1 iPod Nano 5th Generation Click Wheel Replacement, Click Wheel: 手順 1、 2の画像 2

    • Use a heat gun to soften the adhesive underneath the plastic bezel at the bottom of the iPod.

    • Use a low heat setting and do not hold the heat gun in place for too long to avoid melting the plastic bezel.

    • Use a plastic opening tool to pry the bezel from the case of the iPod and remove it.

    翻訳

  2. iPod Nano 5th Generation Click Wheel Replacement: 手順 2、 3の画像 1 iPod Nano 5th Generation Click Wheel Replacement: 手順 2、 3の画像 2 iPod Nano 5th Generation Click Wheel Replacement: 手順 2、 3の画像 3

    • Unscrew three screws from the bottom of the iPod:

    • Two 4.4 mm angled Phillips screws

    • One 5.4 mm Phillips screw.

    • These screws may not come out on their own, so be sure not to lose them when removing the retainer.

    • Use a plastic opening tool to pry the metal retainer out from the bottom of the iPod and remove it.

    翻訳

  4. iPod Nano 5th Generation Click Wheel Replacement: 手順 3、 2の画像 1 iPod Nano 5th Generation Click Wheel Replacement: 手順 3、 2の画像 2

    • Insert a metal spudger into the slot at the bottom of the iPod just above the dock connector.

    • Use the metal spudger to pry up the bottom edge of the click wheel.

    翻訳

  5. iPod Nano 5th Generation Click Wheel Replacement: 手順 4、 2の画像 1 iPod Nano 5th Generation Click Wheel Replacement: 手順 4、 2の画像 2

    • Place a guitar pick between the click wheel and the case of the Nano and remove the metal spudger.

    • Pry up the edges of the click wheel with the guitar pick until the click wheel comes free from the case.

    • Do not try to completely remove the click wheel yet, as it is still held in place by a ribbon cable.

    翻訳

  6. iPod Nano 5th Generation Click Wheel Replacement: 手順 5、 2の画像 1 iPod Nano 5th Generation Click Wheel Replacement: 手順 5、 2の画像 2

    • Lift the click wheel out of the way with one hand and use a plastic opening tool to pry the click wheel ribbon cable connector off its socket on the logic board.

    • Remove the click wheel.

    翻訳
終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

6人の作成者と共同で作成されました。

Matthew Newsom

メンバー登録日: 01/05/10

39,527 ポイント

67のガイドは作成済み

バッジ: 47

+44 個以上のバッジ

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 11

今までの合計 1,175