メインコンテンツにスキップ

iPod Nano 2nd Generation Bottom Bezel Bracket Replacement

必要な工具と部品

  1. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement, Bottom Bezel: 手順 1、 1の画像 1
    • Before opening your iPod, ensure that the hold switch is in the locked position.

  2. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 手順 2、 1の画像 1
    • When removing the the bottom bezel, be sure not to bend the plastic surrounding the dock connector.

    • Carefully insert an iPod opening tool in the seam between the metal casing and white plastic bezel

    • Lift the bottom bezel off the iPod. It's glued on using a mild adhesive, so some force may be required.

  3. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement, Bottom Bezel Bracket: 手順 3、 1の画像 1
    • Remove the following two screws:

    • One #00 Phillips screw with a large head near the headphone jack.

    • One #00 Phillips screw with a smaller head near the side of the iPod. This screw strips easily, so be sure to press down firmly on the screwdriver.

  4. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 手順 4、 1の画像 1
    • Use a metal spudger to carefully pry the headphone jack out of the casing. DO NOT remove the headphone jack from the iPod entirely, as it is connected via a fragile ribbon connector to the click wheel.

  5. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 手順 5、 1の画像 1
    • Slide the headphone jack out until the white plastic housing is no longer held in place by the metal casing.

  6. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 手順 6、 1の画像 1
    • Remove the newly-revealed Phillips #00 screw from beneath the headphone jack.

  7. iPod Nano 2nd Generation Bottom Bezel Bracket Replacement: 手順 7、 1の画像 1
    • Lift the bottom bezel bracket out of the iPod.

終わりに

To reassemble your device, follow these instructions in reverse order.

7 の人々がこのガイドを完成させました。

iRobot

メンバー登録日: 09/24/09

1 ポイント

636のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 1

過去 7 日: 5

過去 30 日: 20

今までの合計 17,678