1. Before opening your iPod, ensure that the hold switch is in the locked position.  The orange bar should be visible, indicating hold is active.
    • Before opening your iPod, ensure that the hold switch is in the locked position. The orange bar should be visible, indicating hold is active.

  2. Insert an opening pick as far as possible into the seam between the plastic front and the metal rear panel, on the right edge of the iPod.
    • Insert an opening pick as far as possible into the seam between the plastic front and the metal rear panel, on the right edge of the iPod.

      • You may need to rock the pick back and forth to slide it in farther.

    • Use the opening pick to pry up against the plastic front panel and release five retaining tabs (seen in the third photo).

    • Slide the pick along the edge of the iPod and continue prying to release the rest of the retaining tabs.

    • After all five tabs along the right side are free, the case should easily open.

    • The iPod case is now open, but don't separate the two halves just yet. There is still an orange ribbon cable connecting the headphone jack to the logic board.

    • Open the case like a book with the dock connector edge at the top, and lay the rear panel next to the front half of the iPod.

    • Use a plastic tool or your fingernails to carefully disconnect the orange headphone jack cable. Be sure to pull straight up on the connector, not the cable itself.

    • Remove the 2 silver T6 Torx screws from the headphone jack.

    • Grasp the headphone jack board and lift it out of the iPod.

    • Turn the headphone jack board over.

    • Use the tip of your finger or a spudger to carefully flip up the black connector holding the headphone jack cable connector in place.

    • Pull the orange headphone jack cable directly out of its connector.

まとめ

To reassemble your device, follow these instructions in reverse order.

16 の人々がこのガイドを完成させました。

iRobot

メンバー登録日: 2009年09月24日

1 ポイント

623のガイドは作成済み

How do you add a "confirmed success"? This worked perfectly for me. Thanks iRobot!

I agree that these pry tools pretty low quality. They did work faster than the guitar picks I've used in the past, but the material is just not durable. They were pretty much destroyed after one case opening.

anja - 返信

The instructions are great, however when you ask about spares required there is no mention of the ribbon cable I require, just the board assembly!

Chris Stockley - 返信

Hi

Where can I buy these components?

Thanks

Pablo Carter - 返信

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 24

今までの合計 21,376