はじめに

The plastic front half of your iPod case.

Before opening your iPod, ensure that the hold switch is in the locked position.
  • Before opening your iPod, ensure that the hold switch is in the locked position.

コメントを追加する

Opening the iPod can be challenging; don't get discouraged if it takes you a few tries to get the iPod to open.
  • Opening the iPod can be challenging; don't get discouraged if it takes you a few tries to get the iPod to open.

  • Insert a plastic iPod opening tool in the seam between the white plastic front and metal back of the iPod. It helps to hold the iPod at top and bottom as shown and squeeze to help pop out the edge. Once you've inserted the tool, run it along the seam to free the five tabs holding the iPod together.

コメントを追加する

Continue to run the opening tool along the side of the case until all five tabs have been released.
  • Continue to run the opening tool along the side of the case until all five tabs have been released.

コメントを追加する

Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.
  • Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.

コメントを追加する

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.
  • Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.

  • Lift the rear panel away from the iPod.

コメントを追加する

Lift the battery up from the adhesive holding it to the iPod.
  • Lift the battery up from the adhesive holding it to the iPod.

  • Lay the battery next to the iPod (it is still connected to the logic board).

コメントを追加する

Carefully disconnect the orange ribbon cable from the hard drive.
  • Carefully disconnect the orange ribbon cable from the hard drive.

  • If the cable doesn't come free easily, it may be helpful to gently wiggle the cable from side to side.

  • Lift the hard drive out of the iPod.

コメントを追加する

Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.
  • Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.

コメントを追加する

Peel up the gray rubber bumper near the hard drive ribbon to reveal the T6 Torx screw beneath.
  • Peel up the gray rubber bumper near the hard drive ribbon to reveal the T6 Torx screw beneath.

  • Remove the newly revealed T6 Torx screw.

コメントを追加する

Remove the 3 remaining T6 Torx screws from the logic board.
  • Remove the 3 remaining T6 Torx screws from the logic board.

コメントを追加する

Slide the logic board away from the port end of the casing and lift it out of the iPod.
  • Slide the logic board away from the port end of the casing and lift it out of the iPod.

コメントを追加する

Front panel remains.
  • Front panel remains.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

iRobot

メンバー登録日: 2009年09月24日

1 ポイント

750のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 6

過去 30 日: 8

今までの合計 5,772