メインコンテンツにスキップ

iPhone 6 Plus Logic Board Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. iPhone 6 Plus Logic Board Replacement, Logic Board: 手順 1、 1の画像 1
    この手順で使用する道具:
    Standoff Screwdriver for iPhones
    $5.49
    購入する
    • Remove the following screws securing the logic board to the rear case:

    • Two 2.4 mm standoff screws

    • Standoff screws are best removed using a standoff screwdriver or bit.

    • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

    • One 2.1 mm Phillips #00 screw

  2. iPhone 6 Plus Logic Board Replacement: 手順 2、 1の画像 1
    • Carefully raise—but do not remove—the logic board, lifting it from the bottom edge nearest the Lightning connector.

  3. iPhone 6 Plus Logic Board Replacement: 手順 3、 1の画像 1
    • Do not remove the logic board. At this point it is still tethered to the rear case via an antenna connector.

    • Continue carefully lifting the bottom side of the logic board until it is vertical.

  4. iPhone 6 Plus Logic Board Replacement: 手順 4、 2の画像 1 iPhone 6 Plus Logic Board Replacement: 手順 4、 2の画像 2
    • Gently lay the logic board upside-down, with the top portion resting against the rear case of the iPhone.

    • Use the flat end of a spudger to disconnect the antenna connector from its socket on the back of the logic board.

  5. iPhone 6 Plus Logic Board Replacement: 手順 5、 1の画像 1
    • Lift and remove the logic board out of the iPhone.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

作成者

6人の作成者と共同で作成されました。

Walter Galan

693,936 ポイント

1,203のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 571