メインコンテンツにスキップ

iPhone 4S Speaker Enclosure Assembly Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. iPhone 4S Speaker Enclosure Assembly Replacement, Speaker Enclosure Assembly: 手順 1、 2の画像 1 iPhone 4S Speaker Enclosure Assembly Replacement, Speaker Enclosure Assembly: 手順 1、 2の画像 2
    • Remove the following screws securing the dock connector cable cover to the logic board:

    • One 1.5 mm Phillips screw

    • One 1.2 mm Phillips screw

    • Remove the metal dock connector cable cover.

  2. iPhone 4S Speaker Enclosure Assembly Replacement: 手順 2、 1の画像 1
    • Use the edge of a plastic opening tool to pry the dock cable up from its socket on the logic board.

  3. iPhone 4S Speaker Enclosure Assembly Replacement: 手順 3、 1の画像 1
    • Peel the dock connector cable off the adhesive securing it to the logic board and the side of the speaker enclosure.

  4. iPhone 4S Speaker Enclosure Assembly Replacement: 手順 4、 2の画像 1 iPhone 4S Speaker Enclosure Assembly Replacement: 手順 4、 2の画像 2
    • Use the edge of a plastic opening tool to pry the cellular antenna cable up from its socket on the logic board.

    • De-route the cellular antenna cable out from under the metal fingers attached to the logic board.

  5. iPhone 4S Speaker Enclosure Assembly Replacement: 手順 5、 1の画像 1
    • Remove the two 2.4 mm Phillips screws securing the speaker enclosure assembly to the outer case.

  6. iPhone 4S Speaker Enclosure Assembly Replacement: 手順 6、 1の画像 1
    • Remove the small black spacer that was under the Phillips screw near the vibrator.

  7. iPhone 4S Speaker Enclosure Assembly Replacement: 手順 7、 3の画像 1 iPhone 4S Speaker Enclosure Assembly Replacement: 手順 7、 3の画像 2 iPhone 4S Speaker Enclosure Assembly Replacement: 手順 7、 3の画像 3
    • Use a plastic opening tool to lift the speaker enclosure assembly out of the case, being sure not to damage the EMI fingers on the attached Wi-Fi antenna.

    • Remove the speaker enclosure assembly.

    • Before reinstalling the speaker enclosure assembly's screws, be sure the Wi-Fi grounding fingers are installed below the lip in the iPhone's metal case as seen in the third picture.

    • Before reassembly, be sure to clean all metal-to-metal contact points between the grounding fingers of the Wi-Fi antenna and the case of the iPhone with a de-greaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to cause wireless interference issues.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

作成者

5人の作成者と共同で作成されました。

Walter Galan

694,692 ポイント

1,203のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 726