修理を始めるには コミュニティ ストア

iPhone 4 Verizon Rear Panel Replacement

はじめに

Remove the rear panel to access components inside your iPhone 4.

必要な工具と部品

ビデオの概要

  1. iPhone 4 Verizon Rear Panel Replacement, Rear Panel: 手順 1、 1の画像 1

    • Before you begin, discharge your iPhone battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

    • Power off your iPhone before beginning disassembly.

    • Your phone's rear cover may have two #000 Phillips screws or Apple's 5-Point "Pentalobe" screws. Check which screws you have, and ensure you also have the correct screwdriver in order to remove them.

    • Remove the two 3.6 mm Pentalobe or Phillips #000 screws next to the dock connector.

    編集

    Pra descarregar a bateria, antes de fazer o serviço, isso serve pra qualquer celular?

    Gilmar Dutra - 返信

  3. iPhone 4 Verizon Rear Panel Replacement: 手順 2、 2の画像 1 iPhone 4 Verizon Rear Panel Replacement: 手順 2、 2の画像 2

    • Push the rear panel toward the top edge of the iPhone.

    • The panel will move about 2 mm.

    編集

  4. iPhone 4 Verizon Rear Panel Replacement: 手順 3、 1の画像 1

    • Pinch the rear panel with your fingers, and lift it away from the iPhone. Alternatively, use a Small Suction Cup .

    • Be careful not to damage the plastic clips attached to the rear panel.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

114 の人々がこのガイドを完成させました。

作成者

16人の作成者と共同で作成されました。

Andrew Bookholt

591,778 ポイント

619のガイドは作成済み

バッジ: 47

+44 個以上のバッジ

4 件のコメント

Step 1 says the screwdriver should only be used once. Is this correct? Or should it read the screws should only be used once?

Andrew Stevenson - 返信

Took less than 10 minutes! Works perfect. Thanks ifixit!

bsterlin - 返信

Super simple and easy! done i less than 5 minutes!

Gine - 返信

This was a remark made in the products section for the rear glass panel on the Verizon CDMA, "The instructions don't tell you to make sure that you remove the plastic lens from the front facing camera." It is referring to the protective plastic film on the new rear panel that protects the new lens. This should definitely be included in the instructions for replacement of the back panel.

uncletom - 返信

コメントを追加

統計データ:

過去 24時間: 1

過去 7 日: 8

過去 30 日: 10

今までの合計 46,950