iMac Intel 21.5" EMC 2308 Hard Drive Replacement - iFixit 修理ガイド

はじめに

This guide is an internal prerequisite and should remain unpublished.

必要な工具と部品

手順1 Hard Drive

iMac Intel 21.5" EMC 2308 Hard Drive Replacement, Hard Drive: 手順 1、 1の画像 1

Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector reversed from the current orientation so the fans will not run at full speed.
Disconnect the thermal sensor by pulling its connector away from the side of the hard drive.
During reassembly, be sure that the thermal sensor connector is connected to set of pins closest to the SATA connectors. If the fans spin at full speed, reverse the connector's position.

手順2

iMac Intel 21.5" EMC 2308 Hard Drive Replacement: 手順 2、 2の画像 1

iMac Intel 21.5" EMC 2308 Hard Drive Replacement: 手順 2、 2の画像 2

Disconnect the SATA data cable by pulling its connector away from the hard drive.
Use the flat end of a spudger to help disconnect the SATA power connector from the hard drive.

手順3

iMac Intel 21.5" EMC 2308 Hard Drive Replacement: 手順 3、 1の画像 1

Remove the two 9 mm T10 Torx screws securing the upper hard drive bracket to the outer case.

手順4

iMac Intel 21.5" EMC 2308 Hard Drive Replacement: 手順 4、 1の画像 1

Slightly rotate the hard drive out of the outer case and lift it up off its mounting pins toward the top edge of the iMac.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

3人の作成者と共同で作成されました。

Andrew Bookholt

586,133 ポイント

619のガイドは作成済み

+44 個以上のバッジ

0 件のコメント

統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,738