はじめに

Remove the access door to replace RAM chips and remove your front bezel.

パーツ

パーツは必要ありません。

Loosen the two captive Phillips screws securing the access door to the iMac.
  • Loosen the two captive Phillips screws securing the access door to the iMac.

  • Remove the access door from the iMac.

  • Before beginning the repair, unplug the computer and press and hold the power switch for 20-30 seconds, to discharge internal capacitors.

That is a really, really unnecessarily complex way of fitting a new hard drive. Thanks, but no thanks...

annax - 返信

Quote from annax:

That is a really, really unnecessarily complex way of fitting a new hard drive. Thanks, but no thanks...

annax, if you can suggest a simpler way we're all ears!

Jake Simmonds - 返信

I found this guide to be very useful. The installation was super easy, especially since I've never opened my iMac before. I was able to skip steps 6, 7, 9, 10 and 14. Wish I had one of those long skinny magnetic torx screwdriver's though. I had to use duct tape to hold the screws on the end of the bit for step 12.

I used this opportunity to vacuum out the dust with mini attachments. Much needed after 3 years ;0)

Awesome site!!! Thanks for sharing your knowledge and saving me time and $$$!

Eric Patten - 返信

Yes I did it! thanks for this very good manual

Philippe d Anfray - 返信

まとめ

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

Andrew Bookholt

493,881 ポイント

1,172のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 7

過去 30 日: 17

今までの合計 6,231