はじめに

The fan duct directs air across the heat sink on the logic board.

Lay the iMac display-side down on a flat surface.
  • Lay the iMac display-side down on a flat surface.

  • Loosen the three Phillips screws securing the rear panel to the iMac.

  • These screws are captive in the iMac. The center screw will stop turning after about 3.5 turns and the outer screws will stop turning after about 5.5 turns. Do not try to remove these screws from your iMac.

Some models (with light sensor) have only the two outboard screws.

Robert Huber - 返信

Lift the rear panel slightly near the bottom of the iMac. Pull the rear panel toward yourself and remove it from the iMac.
  • Lift the rear panel slightly near the bottom of the iMac.

  • Pull the rear panel toward yourself and remove it from the iMac.

コメントを追加する

MacBook Battery Fix Kits
Fix Kits Starting at $69.99
MacBook Battery Fix Kits
Starting at $69.99
Remove the following two screws:
  • Remove the following two screws:

    • One 11 mm T10 Torx.

    • One 10.6 mm T8 Torx.

Mine were just Philips screws? A1076 model...

pinzberg - 返信

Lift the fan duct out of the chassis.
  • Lift the fan duct out of the chassis.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

4 の人々がこのガイドを完成させました。

Andrew Bookholt

483,472 ポイント

1,139のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 10

今までの合計 8,624