Pry the four rubber feet from the bottom of the iP21 to expose four 11mm screws. Unscrew the four 11mm screws from the base. Pry the base loose using the spudger.
  • Pry the four rubber feet from the bottom of the iP21 to expose four 11mm screws.

  • Unscrew the four 11mm screws from the base.

  • Pry the base loose using the spudger.

  • Remove the base by hand.

コメントを追加する

Remove the two black 6mm screws connecting the main circuit board to the housing top. Grasp front housing and back housing firmly.
  • Remove the two black 6mm screws connecting the main circuit board to the housing top.

  • Grasp front housing and back housing firmly.

  • Gently pull front housing from the back housing.

コメントを追加する

Remove two 9mm screws holding speaker assembly in iP21, using iFixit Phillips #2 bit
  • Remove two 9mm screws holding speaker assembly in iP21, using iFixit Phillips #2 bit

コメントを追加する

Lift speaker assembly Remove four 7mm screws to detach speaker from speaker assembly
  • Lift speaker assembly

  • Remove four 7mm screws to detach speaker from speaker assembly

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Brandy

メンバー登録日: 2014年10月27日

601 ポイント

6のガイドは作成済み

チーム

Eastern Washington University, Team 1-2, Carnegie Fall 2014 Eastern Washington University, Team 1-2, Carnegie Fall 2014人のメンバー

EWU-CARNEGIE-F14S1G2

6 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 120