メインコンテンツにスキップ

はじめに

Use this guide to remove your iHome iP1's back cover. This cover is located on the underside of the platorm connecting the speakers. Although it serves no function other than to protect the motherboard, it is necessary to remove in order to remove many other components of the iHome iP1, such as the speakers and the 30-pin connector.

パーツ

パーツは指定されていません。

  1. Orient the iHome upside down with the speakers facing away from you.
    • Orient the iHome upside down with the speakers facing away from you.

  2. Remove the four 9.5 mm Phillips #2 screws located on each of the four corners of the iHome's back cover. Remove the four 9.5 mm Phillips #2 screws located on each of the four corners of the iHome's back cover.
    • Remove the four 9.5 mm Phillips #2 screws located on each of the four corners of the iHome's back cover.

  3. Remove the back cover by grabbing its sides and lifting it off the iHome.
    • Remove the back cover by grabbing its sides and lifting it off the iHome.

終わりに

To reassemble your device, follow these instructions in reverse order.

Wen Sullivan

メンバー登録日: 2016年10月06日

476 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 20-1, Livingston Fall 2016 Cal Poly, Team 20-1, Livingston Fall 2016人のメンバー

CPSU-LIVINGSTON-F16S20G1

4 メンバー

7のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 139