Skip to main content

はじめに

This guide will assist users in removing and replacing the power switch on the iHome iBT16 device.

  1. Make sure to flip the device over to get into the correct orientation Using the Philips #00 Screwdriver, unscrew and remove the four 9mm black screws on the base plate of the device.
    • Make sure to flip the device over to get into the correct orientation

    • Using the Philips #00 Screwdriver, unscrew and remove the four 9mm black screws on the base plate of the device.

    • Make sure to keep these screws in a safe location so you don't lose them

  2. Using the plastic opening tool, insert  into the crack between the base plate and the main body of the device Using a lever like motion, push the opening tool down thus lifting the plate
    • Using the plastic opening tool, insert into the crack between the base plate and the main body of the device

    • Using a lever like motion, push the opening tool down thus lifting the plate

    • You will need to use your fingers to lift the base plate off the main body of the device

    • The motherboard is directly underneath the base plate

  3. MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now

    MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now
  4. Using the Philips #00 screwdriver, unscrew and remove the two silver 10mm screws holding the motherboard Don't misplace the screws! Keep them in a safe place while working on the device
    • Using the Philips #00 screwdriver, unscrew and remove the two silver 10mm screws holding the motherboard

    • Don't misplace the screws! Keep them in a safe place while working on the device

    • Make sure to ground yourself prior to continuing at this point

  5. Using the plastic opening tool, pull the motherboard out of the casing
    • Using the plastic opening tool, pull the motherboard out of the casing

    • Make sure to lift it out at an angle to the back, as the plastic power switch is attached to the board and can be broken

  6. Desolder the 10 points holding the power switch to the motherboard Once complete, simply remove the switch from the board
    • Desolder the 10 points holding the power switch to the motherboard

    • Once complete, simply remove the switch from the board

まとめ

To reassemble your device, follow these instructions in reverse order.

Ryan Edwards

メンバー登録日: 2017年03月21日

301 ポイント

3のガイドは作成済み

チーム

UMass Dartmouth, Team S3-G6, Botvin Spring 2017 UMass Dartmouth, Team S3-G6, Botvin Spring 2017人のメンバー

UMASSD-BOTVIN-S17S3G6

2 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 10

今までの合計 441