Skip to main content

はじめに

After reading this guide you will know how to replace the micro USB port on an iHomeiBT16.

  1. Make sure to flip the device over to get into the correct orientation Using the Philips #00 Screwdriver, unscrew and remove the four 9mm black screws on the base plate of the device.
    • Make sure to flip the device over to get into the correct orientation

    • Using the Philips #00 Screwdriver, unscrew and remove the four 9mm black screws on the base plate of the device.

    • Make sure to keep these screws in a safe location so you don't lose them

  2. Using the plastic opening tool, insert  into the crack between the base plate and the main body of the device Using a lever like motion, push the opening tool down thus lifting the plate
    • Using the plastic opening tool, insert into the crack between the base plate and the main body of the device

    • Using a lever like motion, push the opening tool down thus lifting the plate

    • You will need to use your fingers to lift the base plate off the main body of the device

    • The motherboard is directly underneath the base plate

  3. MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now

    MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now
  4. Inside the iHome remove the two silver Phillips screws that are on the motherboard.
    • Inside the iHome remove the two silver Phillips screws that are on the motherboard.

    • Connect the ground strap to ground, and then put the strap around your wrist.

  5. Take the motherboard out of the device, use the plastic opening tool to ensure the power switch doesn't get stuck.
    • Take the motherboard out of the device, use the plastic opening tool to ensure the power switch doesn't get stuck.

  6. On the other side of the motherboard unsolder the two biggest solder joints under the micro USB.
    • On the other side of the motherboard unsolder the two biggest solder joints under the micro USB.

  7. On the side of the motherboard that the micro USB connector is there are five surface mount solder joints at the back of the connector. Unsolder these five solder joints.
    • On the side of the motherboard that the micro USB connector is there are five surface mount solder joints at the back of the connector. Unsolder these five solder joints.

まとめ

To reassemble your device, follow these instructions in reverse order.

Steven Ferreira

メンバー登録日: 2017年03月08日

201 ポイント

2のガイドは作成済み

チーム

UMass Dartmouth, Team S3-G6, Botvin Spring 2017 UMass Dartmouth, Team S3-G6, Botvin Spring 2017人のメンバー

UMASSD-BOTVIN-S17S3G6

2 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 3

過去 30 日: 27

今までの合計 623