メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

はじめに

This is an internal prerequisite guide that should remain unpublished.

パーツ

パーツは指定されていません。

  1. Remove the pieces of readily removable tape from around the perimeter of the display. Carefully remove the aluminum tape covering the display data cable connection.
    • Remove the pieces of readily removable tape from around the perimeter of the display.

    • Carefully remove the aluminum tape covering the display data cable connection.

  2. Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display. Use the tip of a spudger to remove the small washer under the screw you just removed.
    • Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display.

    • Use the tip of a spudger to remove the small washer under the screw you just removed.

  3. Manta Driver Kit

    どんな修理にでも対応可能な112ビット

    Upgrade Your Toolbox

    Manta Driver Kit

    Upgrade Your Toolbox
  4. Peel the aluminum/EMI tape off the cast aluminum frame of the clutch hinges.
    • Peel the aluminum/EMI tape off the cast aluminum frame of the clutch hinges.

    • It is not necessary to peel the tape off the thin steel LCD cover.

  5. Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total). Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).
    • Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).

  6. Lift the thin steel LCD cover off the LCD.
    • Lift the thin steel LCD cover off the LCD.

終わりに

To reassemble your device, follow these instructions in reverse order.

Andrew Bookholt

537,342 ポイント

618のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 407