メインコンテンツにスキップ

はじめに

This guide is an internal private guide that serves as a prereq.

パーツ

パーツは指定されていません。

  1. Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).
    • Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

    • If you don't have a 1.5mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

  2. Use your thumbs to slightly separate the rear bezel from the front bezel.
    • Use your thumbs to slightly separate the rear bezel from the front bezel.

    • It is helpful to hold the opposing corner of the display stationary to aid in flexing the rear bezel away from the display.

  3. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  4. Insert the flat end of a spudger into the gap between the front and rear bezels. Rotate your spudger until it is parallel to the front face of the display. Run the spudger around the perimeter of the display to separate the rear bezel from its retaining clips.
    • Insert the flat end of a spudger into the gap between the front and rear bezels.

    • Rotate your spudger until it is parallel to the front face of the display.

    • Run the spudger around the perimeter of the display to separate the rear bezel from its retaining clips.

  5. Lift the rear bezel off the display.
    • Lift the rear bezel off the display.

まとめ

To reassemble your device, follow these instructions in reverse order.

Andrew Bookholt

525,641 ポイント

618のガイドは作成済み

0 件のコメント

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 486