はじめに

One RAM slot will accept PC2700 chips up to 1 GB.

  1. Lay your iBook upside down on a flat surface.
    • Lay your iBook upside down on a flat surface.

    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    • Lift the battery out of the computer.

    コメントを追加する

  2. Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.
    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    コメントを追加する

    • Remove the four silver Phillips screws that secure the RAM shield.

    コメントを追加する

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

    コメントを追加する

    • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

    • Pull the chip directly out from its connectors.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

34 の人々がこのガイドを完成させました。

添付文書

Walter Galan

568,593 ポイント

1,203のガイドは作成済み

Easy-to-follow instructions. I used them to add 1GB RAM to my iBook G4. Thanks to your instructions, I was able to do the job myself. After contacting three Mac repair shops and either not having anyone call me back or else offering to do it for $40 or $109 at a specialty place, I decided to trust your guide and do it myself. Success!

writeforgod - 返信

What ya download

Ibrahim -

コメントを追加する

統計データを表示:

過去 24時間: 3

過去 7 日: 8

過去 30 日: 34

今までの合計 21,966