修理を始めるには iFixitに参加する ストア

iBook G3 Clamshell RAM Replacement

はじめに

One RAM slot will accept PC100 or PC133 chips up to 512 MB.

必要な工具と部品

  1. iBook G3 Clamshell RAM Replacement, Battery: 手順 1、 1の画像 1

    • Use a coin to turn both battery locking screws 90 degrees to the left.

    • Remove the battery cover.

    • Remove the battery from the computer by pulling up on the plastic tab.

    編集

  2. iBook G3 Clamshell RAM Replacement, Airport Card: 手順 2、 1の画像 1

    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free. Note that the keyboard ribbon is still attached to the logic board, so you cannot completely remove the keyboard yet.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (between F4 and F5 key) 180 degrees in either direction and try again.

    • Rotate the keyboard away from the screen and rest it face-down on the trackpad area.

    編集

  3. iBook G3 Clamshell RAM Replacement: 手順 3、 1の画像 1

    • If your computer does not have an airport card, you can skip the next two steps.

    • Grasp the clear plastic tab on the airport card and pull up and toward the display.

    編集

  5. iBook G3 Clamshell RAM Replacement: 手順 4、 1の画像 1

    • Hold the airport card in one hand and use your other hand to remove the antenna cable.

    編集

  6. iBook G3 Clamshell RAM Replacement, Keyboard: 手順 5、 1の画像 1

    • Remove the two Phillips screws that secure the RAM shield.

    編集

  7. iBook G3 Clamshell RAM Replacement: 手順 6、 1の画像 1

    • Grasp the wire metal bracket on top of the RAM shield and pull upward to remove the shield.

    編集

  8. iBook G3 Clamshell RAM Replacement: 手順 7、 1の画像 1

    • Pull up the keyboard connector cable by its clear plastic loop.

    編集

  9. iBook G3 Clamshell RAM Replacement, RAM: 手順 8、 1の画像 1

    • Your laptop should look approximately like this.

    編集

  10. iBook G3 Clamshell RAM Replacement: 手順 9、 1の画像 1

    • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

    • Pull the chip directly out from its connectors.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

19 の人々がこのガイドを完成させました。

作成者

7人の作成者と共同で作成されました。

iRobot

メンバー登録日: 09/24/09

1 ポイント

636のガイドは作成済み

バッジ: 36

+33 個以上のバッジ

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 2

過去 7 日: 13

過去 30 日: 55

今までの合計 22,702