修理を始めるには

修理する権利

ストア

手順2に変更

Olivier Biot — さんによる編集

承認済みの編集 : Taylor Dixon

前
後
変更なし

手順ライン

[* black] DisconnectPlace your hands at the top corners of the bezel (to the side) and lift the bezel 2-3cm from the body by working from the top. After this you can also disengage the bottom of the bezel (the memory modules will prevent the bottom of the bezel to detach first). When reassembling, start with the bottom of the bezel.
[* icon_caution] The top of the bezel hosts a microphone attached to the logic board. Gently lift the bezel to not damage the microphone wiring or connector by accidentally pulling the cable.
[* black] Decide to fully detach the bezel or to keep the microphone cable attached. In principle, there's enough play in the microphone wiring to allow the bezel to lie flat at the top of the chassis.
[* black] '''For fully detaching the bezel''': disconnect the microphone cable connector, removing tape as necessary.
[* black] '''Alternatively''', you may leave the microphone cable attached to the logic board. In this case, the bezel can be placed 'above' the chassis as if the microphone cable forms a hinge.
[* icon_caution] When deciding to keep the microphone attached to the chassis, make sure you don't accidentally damage the microphone or logic board by bumping into the loose bezel.
[* black] DisconnectPlace your hands at the top corners of the bezel (to the side) and lift the bezel 2-3cm from the body by working from the top. After this you can also disengage the bottom of the bezel (the memory modules will prevent the bottom of the bezel to detach first). When reassembling, start with the bottom of the bezel.
[* icon_caution] The top of the bezel hosts a microphone attached to the logic board. Gently lift the bezel to not damage the microphone wiring or connector by accidentally pulling the cable.
[* black] Decide to fully detach the bezel or to keep the microphone cable attached. In principle, there's enough play in the microphone wiring to allow the bezel to lie flat at the top of the chassis.
[* black] '''For fully detaching the bezel''': disconnect the microphone cable connector, removing tape as necessary.
[* black] '''Alternatively''', you may leave the microphone cable attached to the logic board. In this case, the bezel can be placed 'above' the chassis as if the microphone cable forms a hinge.
[* icon_caution] When deciding to keep the microphone attached to the chassis, make sure you don't accidentally damage the microphone or logic board by bumping into the loose bezel.
[* icon_reminder] For the front bezel to sit properly, be sure to tuck the microphone cable and connector into the void next to the camera board.
[* icon_note] When reassembling the bezel, gently guide the microphone connector and cables through the ±1in long slot at the right of the iSight camera. Once the bezel is properly assembled, gently push the microphone connector and cable into the bezel through that slot.

画像2

以前の画像はありません

追加

画像3

以前の画像はありません

追加