メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

手順3に変更

Puruさんによる編集

承認の保留中

変更なし

手順ライン

[* black] Once, the wires are finely soldered and carefully inspected if any of the two cables are interconnected while soldering, let it be there for a minute. If you find any of two wires are soldered together, make sure to wipe the connected solder line off.
[* black]
Once done, make sure that exposed wire will be covered by squeezing the cable towards the edge of the jack. YouThis is a fine trick but do not squeeze too hard since you may break the wire itself.
[* black] It's very insightful to
spray non conductor material or just simply use clear tape to avoid short circuit.circuit between wires.
[* black]
Now push the jack into the iBeats metal exterior spraying quick dry fixerfixer inside the metal exterior so that once the jack is inserted, it resides there firmly. Then push the rubber cable supportRubber Cable Support piece into the other end of the metal exterior the same way. Inspect the picture closely and you may see a little cap between the cable holder and iBeats metal exterior. If you spray quick fixer well and pushed hart, you not gonna see that gap and your iBeats will look seamed properly.
[* black] Once, the wires are finely soldered and carefully inspected if any of the two cables are interconnected while soldering, let it be there for a minute. If you find any of two wires are soldered together, make sure to wipe the connected solder line off.
[* black]
Once done, make sure that exposed wire will be covered by squeezing the cable towards the edge of the jack. YouThis is a fine trick but do not squeeze too hard since you may break the wire itself.
[* black] It's very insightful to
spray non conductor material or just simply use clear tape to avoid short circuit.circuit between wires.
[* black]
Now push the jack into the iBeats metal exterior spraying quick dry fixerfixer inside the metal exterior so that once the jack is inserted, it resides there firmly. Then push the rubber cable supportRubber Cable Support piece into the other end of the metal exterior the same way. Inspect the picture closely and you may see a little cap between the cable holder and iBeats metal exterior. If you spray quick fixer well and pushed hart, you not gonna see that gap and your iBeats will look seamed properly.

画像2

以前の画像はありません

追加