手順1に変更
- Emilie Dancerによって編集
承認済みの編集 : Emilie Dancer
- 前
- 後
- 変更なし
手順ライン
| [title] Overview | |
| [* black] Here is a photo of the entire unit fully disassembled. Most of the hair we need to get at is inside the ends of the brush axle (bottom left of photo). | |
| [* black] I recommend using a medium-large safety pin to dig out the hair/fibres, a pair of scissors to cut the hair off of the brush, and a flat head screw driver to pry the black plastic end caps off with. You may need a small hammer for reassembly. | |
| [* black] There are no screws. Most pieces are held together by plastic pressure. Be careful not to break any plastic clips or pieces or you will need to buy a new unit. | |
| - | [* black] To prevent having to |
| + | [* black] To prevent having to disassemble this unit often, always take a few minutes to cut any hair/fibre off of the brush after each use. |
| [* black] Disassembly and cleaning should take from 30-45 minutes, depending on how much hair is stuck in the unit. |