メインコンテンツにスキップ

手順9に変更

Rene Jeddoreさんによる編集

承認済みの編集 : Rene Jeddore

変更なし

手順ライン

-[title] Remove ribbon cable from board and yaw arm
+[title] Remove ribbon cables from board and yaw arm
[* black] Next you need to peel the ribbon cable off of the yaw arm. It is sticky, but not too bad. I would recommend using a hair dryer to warm it if possible to soften the adhesive.
[* black] Carefully peel it off the yaw arm.
[* black] Remove the brown ribbon cable from the circuit board first. This is another zif slot with a tab the needs to be lifted with your fingernail.
[* black] after the brown cable is removed it is easier to remove the black ribbon cable.
[* black] Set the circuit board aside.