メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

手順6に変更

Steve McGinnさんによる編集

承認の保留中

変更なし

手順ライン

[* icon_note] Do not yank the upper case off quickly. The case is attached to the logic board via a ribbon cable.
[* black] Lift up at the rear of the case and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case.
[* black] There are four plastic clips above the DVD slot, and another above and to the left of the IR sensor. These clips can be very difficult to disengage without prying. They can also be difficult to re-engage during reassembly. If pulled hard this can also cause permeant bending to the plastic near the IR
[* black] There are four plastic clips above the DVD slot, and another above and to the left of the IR sensor. These clips can be very difficult to disengage without prying. They can also be difficult to re-engage during reassembly. If pulled hard this can also cause permeant bending to the plastic near the IR