メインコンテンツにスキップ

手順3に変更

Ron Davisさんによる編集

承認済みの編集 : Ron Davis

変更なし

手順ライン

-[* black] Detach each (5) ribbon from the camera motherboard.
-[* icon_note] To disconnect the cable, use the tip of a spudger or your fingernail to flip up the small retaining flap. Then, you can safely pull the ribbon cable out.
-[* icon_caution] Be sure you are prying up on the hinged retaining flap, not the connector itself.
-[* black] As the name implies, no force is needed to plug in or remove the cable.
-[* icon_reminder] The white line on this ribbon cable marks the edge of the connection area. To reinstall, insert the cable into the connector up to this line, and then close the retaining flap. If the cable doesn’t insert easily up to (or very near to) this line, it’s probably misaligned and needs to be gently removed and repositioned.
+[* yellow] Use the tip of a spudger or your fingernail to flip up the small retaining flaps on the five ZIF connectors on the motherboard.
+ [* icon_caution] Be sure you are prying up on the hinged retaining flap, not the connector itself.
+[* black] Detach the five ribbon cables from the camera motherboard.
+[* icon_reminder] The white line on the ribbon cables mark the edge of the connection area. To reinstall, insert the cables into the connector up to this line, and then close the retaining flap. If a cable doesn’t insert easily up to (or very near to) this line, it’s probably misaligned and needs to be gently removed and repositioned.

画像1

古いバージョン

新しいバージョン

画像2

古いバージョン

新しいバージョン