メインコンテンツにスキップ

手順 13 への変更

- Phillip Takahashiによって編集

承認の保留中

削除
追加
変更なし

手順ライン

[* black] Locate the oil dipstick. It is at the front of the engine along its center line.
[* black] Pull out the oil dipstick, wipe it off, place it all the way back into its hole and remove again.
[* black] Observe the oil level on the end of the dipstick. It should be between the two holes. If the oil isholes or slightly above the top hole, someone.
[* icon_note] This is not your actual
oil will needlevel, but a pre-check to be drained. Ifmake sure the oil is below the bottom hole, orengine will not visible, oil needs to be added.
[* black] Adjust
run dry when you first start it. The oil level as necessary and placewill drop slightly after the dipstick back in its holefirst run when you are doneoil fills the new oil filter.
[* black] Observe the oil level on the end of the dipstick. It should be between the two holes. If the oil isholes or slightly above the top hole, someone.
[* icon_note] This is not your actual
oil will needlevel, but a pre-check to be drained. Ifmake sure the oil is below the bottom hole, orengine will not visible, oil needs to be added.
[* black] Adjust
run dry when you first start it. The oil level as necessary and placewill drop slightly after the dipstick back in its holefirst run when you are doneoil fills the new oil filter.