メインコンテンツにスキップ

手順 9 への変更

- Phillip Takahashiによって編集

承認の保留中

削除
追加
変更なし

手順ライン

[* black] Guide the new filter back up and around the drive shaft, being careful not to get dirt or debris on the seal of the oil filter.
[* black] Place the threaded end of the oil filter onto the engine's oil filter threads and turn the filter clockwise by hand until it is snug. ItTightening the filter should require a moderate amount of your strength, but not all of it.
[* black] Place the threaded end of the oil filter onto the engine's oil filter threads and turn the filter clockwise by hand until it is snug. ItTightening the filter should require a moderate amount of your strength, but not all of it.
[* icon_caution] If the filter is difficult to turn at the beginning of its threads, '''stop'''! You may be cross threading the oil filter. Re-align the oil filter and try again.
[* black] Do not over-tighten your oil filter by using a wrench. Doing so may cause the oil filter seal to leak and will make removing the oil filter very difficult in the future.
[* black] Remove the oil drain pan from under the car.