修理を始めるには コミュニティ ストア

手順33に変更

- David Hodsonによって編集

承認の保留中

前
後
変更なし

手順ライン

-[* black] Keeping the battery compartment in your hand with your fingers holding the screws in place, place the circuit board onto the battery compartment, sliding the screws through the two holes on either side of the speaker in the center.
- [* icon_note] Make sure that the top of the circuit board (the part that says "Brain Game") lines up with the top of the battery compartment (the side with three metal rings on the outside, as opposed to two).
-[* black] Use your fingers to loosely screw the two included nuts onto the screws that should now protrude through the circuit board.
+[* black] Continue holding the screws in place and set the circuit board on top of the battery compartment so that the two screws are fed through the holes on either side of the speaker.
+ [* icon_note] Make sure that the top of the circuit board (the part that says ***Brain Game***) lines up with the side of the battery compartment with three metal rings on the outside, as opposed to two.
+[* black] Hand tighten the two nuts onto the battery compartment screws.