手順7に変更
- Jake Devincenziによって編集
- 前
- 後
- 変更なし
手順ライン
| [* black] Use the same method above to solder the second resistor lead to the circuit board. | |
| [* icon_note] After soldering a joint, if you are going to put the soldering iron down, be sure to place it back in its stand to prevent burning yourself or anything around you. | |
| - | [* black] Cut the extra length of resistor lead with a pair of |
| + | [* black] Cut the extra length of resistor lead with a pair of wire cutters. NASA workmanship standards state that any length up to 2.29 mm is acceptable. |