手順4に変更
- David Hodsonによって編集
- 前
- 後
- 変更なし
手順ライン
| [* black] Place the leads of the resistor through the holes on either side of the rectangle marked ***R1*** on the circuit board. | |
| [* icon_note] It does not matter which end faces which way when installing resistors. | |
| [* black] Turn the board over so that the copper leads are facing up and the resistor leads are pointing straight up in the air. | |
| - | [* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to |
| + | [* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable. |