手順4に変更
- Jake Devincenziによって編集
- 前
- 後
- 変更なし
手順ライン
| - | [* black] Place the leads of the resistor through the holes marked R1 on the circuit board. |
|---|---|
| + | [* black] Place the leads of the resistor through the holes on either side of the rectangle marked R1 on the circuit board. |
| [* black] Turn the board over so that the copper leads are facing up and the resistor leads are pointing straight up in the air. | |
| [* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30^^o^^ down from vertical is acceptable. |