修理を始めるには コミュニティ ストア

手順5に変更

- Sarah Westbergによって編集

承認済みの編集 : Sarah Westberg

前
後
変更なし

手順ライン

[title] Trim to fit
[* black] Using a fine tip on my iron , I again used a 700 degree tip , dabbed the area with liquid flux and soldered the wire to the lead and exposed trace.
[* black] When done I removed tape, cleaned flux off and trimmed wire to length.
-[* black] Please Note: you must have a steady grip on your iron to attach the wire. By using a long wire, you make it easier to keep it in place as you solder and it's so thin you can remove the excess wire with little stress to the repair.
+[* icon_note] You must have a steady grip on your iron to attach the wire. By using a long wire, you make it easier to keep it in place as you solder and it's so thin you can remove the excess wire with little stress to the repair.