手順5に変更
手順ライン
| + | [title] Trim to fit |
|---|---|
| + | [* black] Using a fine tip on my iron , I again used a 700 degree tip , dabbed the area with liquid flux and soldered the wire to the lead and exposed trace. |
| + | [* black] When done I removed tape, cleaned flux off and trimmed wire to length. |
| + | [* black] Please Note: you must have a steady grip on your iron to attach the wire. By using a long wire, you make it easier to keep it in place as you solder and it's so thin you can remove the excess wire with little stress to the repair. |
画像1
以前の画像はありません
追加