メインコンテンツにスキップ

手順1に変更

Richdaveさんによる編集

承認の保留中

変更なし

手順ライン

-[* black] Remove the white tape from the rear of the CCFL assembly
+[* black] Remove the white tape from either end of the rear of the CCFL assembly.
[* red] Carefully remove about 15-20mm of heat shrink from the CCFL cable to allow the end cap to be removed, making sure you ***DO NOT*** cut or nick the wire insulation.
[* icon_caution] The wires have a ***HIGH VOLTAGE*** applied during operation and the insulation may break down if damaged causing a short
-[* violet] While holding the assembly, slowly and gently pull the thick wires up and out of the slots in the white rubber cap.
+[* violet] While holding the assembly, slowly and gently pull the ***THICK*** wires up and out of the slots in the white rubber cap.
[* icon_caution] Pull the wires one at a time ensuring you don't flex the CCFL and break it.
[* yellow] This will reveal the pins and solder joints.