メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

手順1に変更

Cody Longさんによる編集

承認の保留中

変更なし

手順ライン

[* black] Locate the panelRemove printer carriage cover by unscrewing 4 black coarse thread T-10 torx screws, marked with the HP support link sticker inside the printer body ('''as shown''')red circles.
[* black] Releasefter the tab byscrews are removed depress plastic tabs to release the HP support link stickercover from the sides, shown in yellow.
[* black] RemoveThe cover will now come off, and the black screw below the tab ('''as shown''')feed rollers will be accessible.
[* black] Removeicon_note] '''Note''' At this point you should also remove the two black screws closest to the printer tray ('''as shown''')left side panel. It will simply lift off since there is nothing left holding it in place.
[* black] Locate the panelRemove printer carriage cover by unscrewing 4 black coarse thread T-10 torx screws, marked with the HP support link sticker inside the printer body ('''as shown''')red circles.
[* black] Releasefter the tab byscrews are removed depress plastic tabs to release the HP support link stickercover from the sides, shown in yellow.
[* black] RemoveThe cover will now come off, and the black screw below the tab ('''as shown''')feed rollers will be accessible.
[* black] Removeicon_note] '''Note''' At this point you should also remove the two black screws closest to the printer tray ('''as shown''')left side panel. It will simply lift off since there is nothing left holding it in place.

画像1

以前の画像はありません

追加

画像2

以前の画像はありません

追加