メインコンテンツにスキップ

手順2に変更

redactedさんによる編集

承認済みの編集 : redacted

変更なし

手順ライン

+[* black] After removing the bottom plate, you will have visibility of the logic board. Using a spudger, lift the small black latch holding the ribbon cable.
+[* black] Next, using pointed nose tweezers, remove the 4-wire white connector from the logic board.
+[* black] Record the order of the 6 wires soldiered to the board. Using a hot soldering iron and either a solder sucker or de-soldering wick, remove the solder from the 6 wires highlighted on the photo in red.
+[* black] Remove the remaining screws holding the motherboard in place.
+[* black] Place the wires into the solder holes in the correct order using the recorded pattern from the removal steps.
+[* black] Place the board into the sounddock and replace the two screws. Replace the White Connector.
+[* black] Slide the ribbon cable back into the slot and close the latch. and replace the bottom panel and four panel screws

画像1

以前の画像はありません

追加

画像2

以前の画像はありません

追加