メインコンテンツにスキップ

修理を始めるには

修理する権利

パーツ&ツール

手順8に変更

IMI Compさんによる編集

編集が拒否されました。 : Kristen Gismondi

削除済み
追加
変更なし

手順ライン

[* yellow] While holding up the upper case, pull up the black tab of the silver cable away from its connector.
[* icon_note] If there is no black tab, you can also use a spudger to gently pry the connector from its housing. This connector is tall, so be sure to pry straight up.
[* icon_note] If you happen to break your upper case cable when removing the upper case, we stock the [product|IF186-092|cable] individually and we have a [guide|4660|guide] that makes replacing it easy.
[* black] While you have the upper case removed, you may want to take the opportunity to remove dust, hair, etc. It's best to use a can of compressed air, though if you use a brush, make sure that its bristles are made of a material (usually animal hair) that doesn't generate static electricity, which can destroy electronics.
[* icon_note] Upon reassembly, there are 4 grey plastic clips on the optical drive side of the keyboard (refer to second picture). They must be installed in their slots for the keyboard to snap in properly.
[* icon_note] To make the reassamblereassambly process easier, it's better to pull out the clips first by pulling it straight up gentlygently from the upper case part and then put it in the slot at the optical drive side. Be careful not to put too much strength because it will breakbreak so easy.
[* icon_note] To make the reassamblereassambly process easier, it's better to pull out the clips first by pulling it straight up gentlygently from the upper case part and then put it in the slot at the optical drive side. Be careful not to put too much strength because it will breakbreak so easy.