メインコンテンツにスキップ

手順 1 への変更

- Richard Suovanenによって編集

承認済みの編集 : Richard Suovanen

削除
追加
変更なし

手順ライン

[* red] Gently wedgeblack] Remove the following four press-fit connectors with the flat edge of a plastic spudger or opening tool under the ribbons where each of the two cables are connected, and gently lift up to detach the cable. This will allow you to remove the motherboardtool:
[* red] Front-facing camera connector.
[* orange] Rear-facing camera connector.
[* yellow] Digitizer connector
.
[* red] Gently wedgeblack] Remove the following four press-fit connectors with the flat edge of a plastic spudger or opening tool under the ribbons where each of the two cables are connected, and gently lift up to detach the cable. This will allow you to remove the motherboardtool:
[* red] Front-facing camera connector.
[* orange] Rear-facing camera connector.
[* yellow] Digitizer connector
.
[* icon_caution] The rear-facing camera may be held down to the frame with two sided tape. Try to move the camera with the spudger prior to lifting the motherboard If it does not budge, use the same tool to pry it from the frame to avoid damaging the connector cable in the next step.

画像1

古いバージョン

新しいバージョン

画像2

古いバージョン

新しいバージョン