メインコンテンツにスキップ

手順5に変更

Nickさんによる編集

承認済みの編集 : Nick

変更なし

手順ライン

[title] Adjusting the trimpot on the laser
[* black] ***Take a picture and mark where the original position on the laser!***
-[* black] Adjust the laser trimpot very slightly. Depending on how harsh the failure is, the amount before it gets a 80% read rate will vary. You are going to need your Phillips PH1 bit to do this. If you cannot achieve 80%, I would fail the laser assembly and replace the laser, or console.
+[* black] Adjust the laser trimpot very slightly. Depending on how bad the failure is, the amount you will adjust it before it gets a 80% read rate will vary. You are going to need your Phillips PH1 bit to do this.
[* icon_caution] ***Do not overdo this! Adjusting it too much will wear the motor sooner then expected or burn your games!***
+[* icon_reminder] Anything less then 80% read rates after adjusting it as far as it goes should be failed and the laser should be replaced.