メインコンテンツにスキップ

手順5に変更

Nickさんによる編集

承認済みの編集 : Nick

変更なし

手順ライン

[title] Adjusting the trimpot on the laser
[* black] ***Take a picture and mark where the original position on the laser!***
-[* black] Adjust the laser trimpot very slightly. Depending on how harsh the failure is, the amount before it gets a 60-80% read rate will vary.
+[* black] Adjust the laser trimpot very slightly. Depending on how harsh the failure is, the amount before it gets a 80% read rate will vary. You are going to need your Phillips PH1 bit to do this. If you cannot achieve 80%, I would fail the laser assembly and replace the laser, or console.
[* icon_caution] ***Do not overdo this! Adjusting it too much will wear the motor sooner then expected or burn your games!***
+[* icon_note] ***I cannot tell you how much you have to adjust this. All of these fail in various ways. Some fail and only need a minor adjustment, and some need a major adjustment. Some are beyond adjustment. You will need to experiment with the laser to find the sweet spot.***