メインコンテンツにスキップ

手順5に変更

Nickさんによる編集

承認済みの編集 : Nick

変更なし

手順ライン

[title] Adjusting the trimpot on the laser
-[* icon_caution] ***Do not overadjust the laser. If you overdo this, you run the risk of burning games or burning the motor out prematurely. You will need to reduce the adjustment if you go too far.***
-[* icon_reminder] Anything less then a 80% read rate should be failed if you can. These lasers will not last very long and the damage is probably beyond repair. Replace the laser if you find this is the case.
-[* black] ***Before starting, take a picture of the laser or mark the original position before adjusting the laser.***
-[* black] Adjust the laser trimpot in small amounts at a time. You will need to do this a few times, depending on the extent of the problem. You shot shoot for a 80% read rate as you adjust the laser. Use a ***Phillips PH1*** screwdriver to adjust the trimpot.
+[* icon_caution] ***Do not overadjust the laser. If you overdo this, you run the risk of burning games or burning the motor out prematurely. If you go too far, back off a little bit until you get it right.***
+[* icon_reminder] Anything less then a 80% read rate should be considered a failure. This is because the laser probably does not have much life left in it and replacement is a better option. If you are dealing with one of these systems, its's best to find a good used laser that works, or a NOS one.
+[* black] ***Before starting, take a picture of the laser and mark the original position before adjusting the laser.***
+[* black] Adjust the laser trimpot in small amounts at a time. Using a ***Philips PH1*** screwdriver, turn the trimpot a few times. Do this until you can confirm the laser reads games again, and test the average for the amount of games successfully read.