メインコンテンツにスキップ

手順4に変更

Andrew Saundersさんによる編集

承認済みの編集 : Andrew Saunders

変更なし

手順ライン

-[* red] Use a socket wrench with a 3/8" hex driver to remove the two 26mm screws at the back of the engine shield.
-[* orange] Use a socket wrench with a 5/16" hex driver to remove the 17mm screw on the top of the engine shield.
+[* red] Use a socket wrench with a 3/8" hex bit to remove the two 26mm screws at the back of the engine shield.
+[* orange] Use a socket wrench with a 5/16" hex bit to remove the 17mm screw on the top of the engine shield.