手順1に変更
- Christina Waldenによって編集
承認済みの編集 : Christina Walden
- 前
- 後
- 変更なし
手順ライン
| [* black] Remove all the marked screws using a PH00 screwdriver. | |
| [* red] Remove the two 3mm screws on the grip. | |
| [* orange] Remove the two 4mm screws on the side opposite the grip. | |
| [* yellow] Remove the three 4mm screws on the base of the camera. | |
| [* green] Remove the four 3mm screws on the base of the camera. | |
| - | [* red] Separate the two parts of the body of the camera slightly. |
| [* icon_note] Make sure not to pull too hard because there are connector ribbons. | |
| [* icon_note] Detach the connector ribbons before fully separating the camera into two pieces. This is outlined in the next step. |