手順1に変更
- Carmen Dangによって編集
承認済みの編集 : Carmen Dang
- 前
- 後
- 変更なし
手順ライン
| - | [* black] Remove all the marked screws. |
|---|---|
| + | [* black] Remove all the marked screws using a PH00 screwdriver. |
| [* red] On the bottom, remove the four 3mm screws around the tripod screw hole on the bottom. | |
| [* blue] Remove the three 4mm screws on the sides of that bottom that is still remaining. | |
| [* blue] Remove the two 3mm screws on the grip. | |
| [* blue] Remove the two 4mm screws on the side opposite the grip. | |
| [* blue] Separate the two parts of the body of the camera slightly. | |
| [* icon_note] Make sure not to pull too hard because there are connector ribbons. | |
| [* icon_note] Detach the connector ribbons before fully separating the camera into two pieces. This is outlined in the next step. |